Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 92
managed-device address
To configure the managed device address, use the managed-device address command. To remove
the managed device ip address, use the no managed-device address. This no manage-device
command is added in NAM 6.0(1).
no managed-device address
managed-device address <ip-address>
Note This command is not supported on NAM-1, NAM-2, NME-NAM-80S,
NME-NAM-120S and the NAM Virtual Blade devices.
Syntax Description
ip-address
Specifies the IP address of the managed device.
Syntax Description
Defaults
No default behavior or values.
Command Modes
Command mode
Usage Guidelines
This command is supported only on Cisco NAM 2200 Series appliances.
Examples
The following example sets the managed device IP address, and then shows the managed device:
[e-mail]# managed-device address 10.0.0.1
[e-mail]# show managed-device
[e-mail]# 10.0.0.1
[e-mail]# no managed-device address
Managed Device Address removed if any!
[e-mail]#