Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 62
email
To set up an e-mail server that sends both alarm and report data through e-mail, enable or disable
alarm messages sent through e-mail, and to enter the subcommand mode, use the email command.
To remove the e-mail server, use the no email server command. To stop sending out both scheduled
report data and alarm messages through e-mail, use the no email alarm command.
email
no email server
no email alarm
Syntax Description
This command has no arguments or keywords.
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
Note Recipients are the alarm message recipients. Report data recipients are not supported on CLI.
When you enter the e-mail subcommand mode, the following commands are available:
 ? or help—Displays help; see the ―Error! Reference source not found.‖ command section.
 cancel—Discards changes and exits from the subcommand mode.
 exit—Saves changes and exits from the subcommand mode; see the exit command section.
 server email-server—Specifies the e-mail server name.
 alarm enable— Enables sending alarm messages through e-mail.
 alarm disable—Disables sending alarm messages through e-mail.
 alarm recipients space-separated-list-of-email-addresses— List of email addresses like
[e-mail], [e-mail].
Examples
This example shows how to set up the NAM to send scheduled reports through e-mail to
[e-mail] and [e-mail]: