Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 60
device waas
To create Wide Area Application Services (WAAS) device, use the device waas command.
device waas
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the device WAAS submode, the following commands are available:
 address—IP address of the device. This is a mandatory value.
 passthru—This is the passthru enable or disable traffic from the WAAS device.
 cancel—Discards changes and exits from the subcommand mode.
 exit—Saves changes and exits from the subcommand mode; see the exit command section.
 help—Displays help and keeps you in the application group subcommand mode; see the ―help‖
command section.
 show—Shows the current configuration which is applied on exit.
Examples
This example shows how to create a WAAS device:
[e-mail]# device waas
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.
[e-mail](sub-device-waas)# ?
? - display help
address - device IP address (*)
cancel - discard changes and exit from subcommand mode
exit - create device and exit from sub-command mode
help - display help
passthru - enable/disable passthru traffic from WAAS device
show - show current config that will be applied on exit
(*) - denotes a mandatory field for this configuration.