Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 58
device netflow
To create a NetFlow Data Export (NDE) device, use the device netflow command.
device netflow
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the device netFlow submode, the following commands are available:
 address—IP address of the device. This is a mandatory value.
 community—SNMPv2c community string
 cancel—Discards changes and exits from the subcommand mode.
 exit—Saves changes and exits from the subcommand mode; see the exit command section.
 help—Displays help and keeps you in the application group subcommand mode; see the help
command section.
 show—Shows the current configuration which is applied on exit.
 snmp-version—The version of SNMP that is used to communicate with the device
 v3-auth-passphrase—SNMPv3 authentication passphrase
 v3-auth-protocol—SNMPv3 authentication protocol
 v3-priv-passphrase—SNMPv3 privacy passphrase
 v3-priv-protocol—SNMPv3 privacy protocol
 v3-sec-level—SNMPv3 security level
 v3-username—SNMPv3 username
Examples
This example shows how to create a netFlow device:
[e-mail]# device netflow
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.