Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 57
device erspan
To create an ERSPAN (Encapsulated Remote SPAN) device, use the device erspan command.
device erspan
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the device erspan submode, the following commands are available:
 address—IP address of the device. This is a mandatory value.
 cancel—Discards changes and exits from the subcommand mode.
 exit—Saves changes and exits from the subcommand mode; see the exit command section.
 help—Displays help and keeps you in the application group subcommand mode; see the help
command section.
 show—Shows the current configuration which is applied on exit
Examples
This example shows how to create an ERSPAN device:
[e-mail]# device erspan
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.
[e-mail](sub-device-erspan)# ?
? - display help
address - device IP address (*)
cancel - discard changes and exit from subcommand mode
exit - create device and exit from sub-command mode
help - display help
show - show current config that will be applied on exit
(*) - denotes a mandatory field for this configuration.