Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 47
data-source netflow
To create NetFlow Data Export (NDE) data-source, use the data-source netflow command.
data-source netflow
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the data-source netFlow submode, the following commands are available:
 device-id—NetFlow device ID. This is a mandatory value.
 engine-id—NetFlow engine ID
 cancel—Discards changes and exits from the subcommand mode.
 exit—Saves changes and exits from the subcommand mode.
 help—Displays help and keeps you in the application group subcommand mode.
 name string—Sets the netFlow data-source name. This is a mandatory value.
 show—Shows the current configuration which is applied on exit
Examples
This example shows how to create a netFlow data-source:
[e-mail]# data-source netflow
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.
[e-mail](sub-data-source-netflow)# ?
? - display help
cancel - discard changes and exit from subcommand mode
device-id - netflow device ID (*)
engine-id - netflow Engine ID
exit - create data-source and exit from sub-command mode
help - display help
name - data-source name (*)
show - show current config that will be applied on exit
(*) - denotes a mandatory field for this configuration.