Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 28
cdp hold-time
To set the Cisco Discovery Protocol (CDP) messages hold time, use the cdp hold-time command.
To return the CDP messages hold time to the default value, use the no form of this command.
cdp hold-time time
no cdp hold-time
Note This command is not valid for NAM-1 or NAM-2 devices or the Cisco NAM
2200 Series appliances.
Syntax Description
time
Specifies the CDP hold time. Range is from 10 to 255
seconds.
Syntax Description
Defaults
180 seconds.
Command Modes
Command mode
Examples
This example shows how to set the CDP messages hold time:
[e-mail]# cdp hold-time 30
[e-mail]#
Related Commands
Error! Reference source not found.