Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 248
web-user
To enter the web user configuration subcommand mode, and then configure local web users on the
NAM, use the web-user command. To remove a web user from your configuration, use the no form
of this command.
web-user
no web-user username
Syntax Description
username
Sets the username.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the web user subcommand mode, the following commands are available:
 account-mgmt enable | disable—(Optional) Enables or disables the account management
privilege.
 alarm-config enable | disable—(Optional) Enables or disables the alarm configuration privilege.
 cancel—Discards changes and exits from the subcommand mode.
 capture enable | disable—(Optional) Enables or disables the packet capture and decode
privilege.
 collection-config enable | disable—(Optional) Enables or disables the collection configuration
privilege.
 exit—Saves changes and exits from the subcommand mode; see the exit command.
 system-config enable | disable—(Optional) Enables or disables the system configuration
privilege.
 user-name username—Sets the username.