Manualshelf

Reference Guide

ManualsBrandsCisco ManualsInterface ModulesCisco Catalyst 6500 Series Firewall Services Module
231232233234235236237238239240
Cisco Prime Network Analysis Module Command Reference Guide Page 240
trap-dest
To enter the trap destination subcommand mode and create or edit trap destinations on the NAM, use
the trap-dest command. To remove a trap destination entry, use the no form of this command.
trap-dest
no trap-dest [control-index]
Syntax Description
control-index
(Optional) Specifies the collection control index.
Range is from 1 to 65535.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the trap destination subcommand mode, the following commands are available:
address—Sets the trap destination IP address.
cancel—Discards changes and exits from the subcommand mode; see the
autocreate-data-source section.
community community_string—Sets the community string.
exit—Saves changes and exits from the subcommand mode; see the exit command.
index index—(Optional) Sets the trap index. Range is from 1 to 65535. Default is random.
owner string—(Optional) Specifies the collection owner. Default is monitor. This option is
removed in NAM 6.0(1).
Note The collections that are configured in the CLI will not be visible in the GUI. For collections that use a GUI
screen, you can make them visible in the GUI by using the owner string ―LocalMgr.‖
port—(Optional) Sets the UDP port. Default is 162.