Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 236
help - display help
ptp-ip-address - set the ip address of the ptp interface
sync - synchronize NAM system time with switch or ntp
[e-mail](sub-time)# sync switch
[e-mail](sub-time)# exit
Successfully updated NAM system time settings.
NOTE:You have configured the NAM synchronize time to the switch.
For this change to take effect, set the time from the switch or
reset the NAM.
[e-mail]# show time
NAM synchronize time to: Switch
Timezone configured on the switch:PST
Switch time offset to UTC: 0
Current system time: Thu Mar 20 09:23:14 GMT 2003
This example shows how to configure system time settings on the NAM to synchronize the time
with the NTP:
[e-mail]# time
Entering into subcommand mode for this command.
Type 'exit' to come out of this mode.
Type 'cancel' to discard changes and to come out of this mode.
[e-mail](sub-time)# sync ntp ntp01.cisco.com ntp02.cisco.com
[e-mail](sub-time)# exit
Successfully updated NAM system time settings.
[e-mail]# show time
NAM synchronize time to: NTP
NTP server1: ntp01.cisco.com
NTP server2: ntp02.cisco.com
Current system time: Thu Mar 20 09:23:36 GMT 2003
[e-mail]#
Related Commands
show time