Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 235
time
To enter the time configuration subcommand mode, and then configure NAM system time settings,
use the time command.
time
Syntax Description
This command has no arguments or keywords.
Defaults
This command has no default settings.
Command Types
Switch command
Command Modes
Privileged
Usage Guidelines
When you enter the time configuration subcommand mode, the following commands are available:
 cancel—Discards changes and exits from the subcommand mode.
 exit—Saves changes and exits from the subcommand mode; see the exit command.
 sync ntp | switch—(Optional) Synchronizes the NAM system time with the Network Time
Protocol (NTP) or with the switch.
 zone—region-name [zone-name]—Synchronizes the time zone with the NAM for use with NTP.
 ptp-ip-address—Sets the ip address of the ptp interface.
Examples
This example shows how to configure system time settings on the NAM to synchronizes the time
with the switch:
[e-mail]# time
Entering into subcommand mode for this command.
Type 'exit' to come out of this mode.
Type 'cancel' to discard changes and to come out of this mode.
[e-mail](sub-time)# ?
? - display help
cancel - discard changes and exit from subcommand mode
exit - exit from subcommand mode