Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 224
show waas data-source
To display the WAAS devices configured on the NAM device, use the show waas data-source
command.
show waas data-source [datasrc-index]
Syntax Description
datasrc-index
(Optional) Displays the data source index
Syntax Description
Defaults
The default behavior is to show all WAAS data sources unless a specific data source index is
specified.
Command Modes
Command mode
Usage Guidelines
This command is supported on all NAM platforms.
The show waas data-source command displays information about WAAS data sources currently
configured on the NAM.
Examples
The following example shows the system inventory information:
[e-mail]# show waas data-source
[e-mail]#