Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 22
Examples
This example shows how to create an application group named appGrpSample with two protocols in
the group:
root@NAM# application group
Entering into subcommand mode for this command.
Type 'exit' to come out of this mode.
Type 'cancel' to discard changes and to come out of this mode.
root@NAM(sub-application-group)# ?
? - display help
add - add a protocol to the group (*)
cancel - discard changes and exit from subcommand mode
delete - remove a protocol from the group (*)
exit - exit from subcommand mode
help - display help
name - set application group name (*)
(*) - denotes a mandatory field for this configuration.
root@NAM(sub-application-group)# add 16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.3.68.4.0.1.0.0
root@NAM(sub-application-group)# add 16.1.0.0.1.0.0.8.0.0.0.0.17.0.0.4.60.4.0.1.0.0
root@NAM(sub-application-group)# name appGrpSample
root@NAM(sub-application-group)# exit
Sucessfully create application group appGrpSample.
root@NAM#
root@NAM#
root@NAM# show application group appGrpSample
Application Group: appGrpSample
Number of Protocols: 2
- w-ether2.ip.tcp.tcp-836
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.3.68.4.0.1.0.0
- w-ether2.ip.udp.udp-1084
16.1.0.0.1.0.0.8.0.0.0.0.17.0.0.4.60.4.0.1.0.0
root@NAM#
Related Commands
show application group