Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 16
2: NAM CLI Commands:
application - device waas
___________________________________________
This chapter contains an alphabetical listing of the commands unique to the Cisco platforms that
support the 5.1(2), 5.1(3), 6.0(1) and 6.0(2) releases. For information on the supported platforms, see
the Cisco Prime Network Analysis Module Release Notes.
For information on Cisco IOS commands to configure your specific hardware platform, see Related
Documentation.
For ease of use, NAM CLI Commands, are divided into five different chapters:
 2: NAM CLI Commands:
application - device waas
___________________________________________ (this chapter)
 3: NAM CLI Commands:
email – logout
___________________________________________
 4: NAM CLI Commands:
metric export host - show certificate request
___________________________________________
 5: NAM CLI Commands:
show classification-settings to show monitor urlfilter
 6: NAM CLI Commands:
show password strong-policy - web user
___________________________________________
This chapter describes the following commands:
 application
 application group
 audit-trail enable
 autocreate-data-source
 Error! Reference source not found.
 cdp hold-time
 cdp interval
 classification-mode default
 To use default NAM packet classification, use the classification-mode default command.
This command is added in NAM 6.0(1).