Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 141
show application group
To display application groups, use the show application group command.
show application group [group-name]
Syntax Description
group-name
(Optional) Specifies the application group name.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode
Examples
This example shows how to display application groups:
[e-mail]# show application group
Application Group: File-Transfer
Number of Protocols: 5
- ftp
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.0.21.4.0.1.0.0
- ftp-data
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.0.20.4.0.1.0.0
- ftps
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.3.222.4.0.1.0.0
- ftps-data
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.3.221.4.0.1.0.0
- tftp
16.1.0.0.1.0.0.8.0.0.0.0.17.0.0.0.69.4.0.1.0.2
Application Group: Peer-to-Peer
Number of Protocols: 12
- gnutella(6346)
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.24.202.4.0.1.0.0
- gnutella(6347)
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.24.203.4.0.1.0.0
- fasttrack(udp)
16.1.0.0.1.0.0.8.0.0.0.0.17.0.0.4.190.4.0.1.0.0
- fasttrack(tcp)
16.1.0.0.1.0.0.8.0.0.0.0.6.0.0.4.190.4.0.1.0.0
- winmx(udp)
16.1.0.0.1.0.0.8.0.0.0.0.17.0.0.24.113.4.0.1.0.
- winmx(tcp)