Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 132
remote-storage sas
To list or format the SAS remote storage targets for capture data, use the remote-storage sas
command.
remote-storage sas
Syntax Description
name
Specifies the name of the SAS remote storage being
removed.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
These commands are supported only on NAM-3.
When you enter the command, the following are available:
 format—Format one or more SAS storage targets.
 fsck—Run FS check on a SAS storage target (may take several minutes).
 label—Label a SAS storage target.
 list—List all the SAS storage targets.
 local-address—Show local SAS address. Use the storage vendor's web interface to map the
NAM local ID to the storage LUNs.
 mount—Reconnects a logically disconnected SAS storage target. Replaces connect command.
 unmount—Disconnects a SAS storage target (so it can be safely removed). Replaces disconnect
command.
Examples
This example shows how to configure a remote storage for capturing SAS data:
[e-mail]# remote-storage sas
fsck - run FS check on a SAS storage target (may take several minutes)