Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 128
remote-storage fcoe
To list or format the FCoE remote storage targets for capture data, use the remote-storage fcoe
command.
remote-storage fcoe
Syntax Description
name
Specifies the name for the FCoE remote storage being
removed.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
These commands are supported only on NAM-3.
When you enter the command, the following are available:
 format—Formats one or more FCoE storage targets.
 fsck—Runs FS check on a FCoE storage target (may take several minutes).
 label—Labels a FCoE storage target.
 list—Lists all the FCoE storage targets.
 local-pwwn—Shows local FCoE Port WWN. Use the storage vendor's web interface to map the
NAM local ID to the storage LUNs.
 mount—Reconnects a logically disconnected FCoE storage target. Replaces connect command.
 refresh—Refreshes the FCoE service.
 sfp-info—Displays important information from the SFP and module EEPROM, including type,
vendor, part number, serial number, and data code.
 unmount—Logically disconnects a FCoE storage target (so it can be safely removed). Replaces
disconnect command.