Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 119
ping6
To check connectivity to a IPv6 network device, use the ping6 command. This command is added in
NAM 6.0(1).
Ping6 [-n | -v] [-c count] [-i wait] [-p pattern] [-s packetsize] [-I interface] [-M hint] hostname | IP address
Syntax Description
-n
(Optional) Displays the network addresses as numbers.
-v
(Optional) Specifies verbose output.
-c count
(Optional) Stops the ping6 after sending the count of
ECHO_REQUEST packets.
-i wait
(Optional) Specifies the time interval in seconds between
sending each packet.
-p pattern
(Optional) Specifies the pad bytes to fill out packets sent in
the ping. You may specify up to 16 pad bytes to fill out
packets being sent.
-s packetsize
(Optional) Sets the 8 bytes of ICMP header data.
-I interface
(Optional)Sets the name of the specific interface. When
pinging IPv6
Link-local address this option is required.
-M hint
(Optional)Select Path MTU Discovery strategy. hint may be
do prohibit fragmentation. Want do PMTU discovery,
fragment locally when packet size is large. Do not set DF
flag.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode