Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 112
netflow input port
To set a specified value of the input NetFlow UDP port on NAM, use the netflow input port [port]
command.
netflow input port [port]
Note In case this CLI is not used, NAM retains the default port 3000 to listen to
incoming NDEs. When invoked, the CLI prints both old and new UDP port
numbers, if successfully completed.
Syntax Description
port
Specifies the input UDP port number, valid values 1 -
65535.
Syntax Description
Defaults
The default port is 3000.
Command Modes
Command mode
Examples
This example shows how to use the netflow input port command.
root@localhost# netflow input port 9101
NetFlow input port 3000 changed to 9101