Data Sheet

© 2016 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 7 of 11
8 Port
16 Port
24 Port
48 Port
Power consumption
(watts)
0% traffic
10% traffic
100% traffic
Weighted average
13.0
14.8
14.9
14.2
19.9
22.0
22.0
21.3
14.9
19.3
19.3
17.8
21.9
27.1
27.1
25.4
19.4
26.5
26.5
24.1
25.9
32.9
32.9
30.6
29.7
41.1
41.1
37.3
68.4
81.6
81.9
77.3
Note: The wattage rating on the power supply does not represent actual power draw. It indicates the maximum power
draw possible by the power supply. This rating can be used for facility capacity planning. For PoE switches, cooling
requirements are smaller than total power draw because a significant portion of the load is dissipated in the endpoints.
Acoustic Noise (48 Port PoE only)
Sound Pressure
LpA (Typical)
35dB
LpAD (Maximum)
39dB
Sound Power
LwA (Typical)
4.8B
LwAD (Maximum)
5.2B
Note: Bystander positions operating mode at 25°C ambient.
Safety and Compliance
Safety
UL 60950-1 Second Edition, CAN/CSA-C22.2 No. 60950-1 Second Edition, EN 60950-1 Second Edition, IEC 60950-1
Second Edition, AS/NZS 60950-1
EMC: emissions
47CFR Part 15 (CFR 47) Class A, AS/NZS CISPR22 Class A, CISPR22 Class A, EN55022 Class A, ICES003 Class
A, VCCI Class A, EN61000-3-2, EN61000-3-3, KN22 Class A, CNS13438 Class A
EMC: immunity
EN55024, CISPR24, EN300386, KN24
Environmental
Reduction of Hazardous Substances (RoHS) including Directive 2011/65/EU
Telco
Common Language Equipment Identifier (CLEI) code
U.S. government
certifications
USGv6 and IPv6 Ready Logo
Connectors and Interfaces
Ethernet interfaces
10BASE-T ports: RJ-45 connectors, 2-pair Category 3, 4, or 5 unshielded twisted-pair (UTP) cabling
100BASE-TX ports: RJ-45 connectors, 2-pair Category 5 UTP cabling
1000BASE-T ports: RJ-45 connectors, 4-pair Category 5 UTP cabling
1000BASE-T SFP-based ports: RJ-45 connectors, 4-pair Category 5 UTP cabling
SFP and SFP+
interfaces
For information about supported SFP/SFP+ modules, refer to the Transceiver Compatibility matrix tables at
cisco.com/en/US/products/hw/modules/ps5455/products_device_support_tables_list.html
Indicator LEDs
Per-port status: link integrity, disabled, activity, speed, and full duplex
System status: system, PoE, and link speed
Console cables
CAB-CONSOLE-RJ45 Console cable 6 ft. with RJ-45
CAB-CONSOLE-USB Console cable 6 ft. with USB Type A and mini-B connectors
Power
Use the supplied AC power cord to connect the AC power connector to an AC power outlet
Management
BRIDGE-MIB
CISCO-CABLE-DIAG-MIB
CISCO-CDP-MIB
CISCO-CLUSTER-MIB
CISCO-CONFIG-COPY-MIB
CISCO-CONFIG-MAN-MIB
CISCO-DHCP-SNOOPING-MIB
CISCO-ENTITY-VENDORTYPE-OID-
MIB
CISCO-ENVMON-MIB
CISCO-ERR-DISABLE-MIB
CISCO-FLASH-MIB
CISCO-PORT-QOS-MIB
CISCO-PORT-SECURITY-MIB
CISCO-PORT-STORM-CONTROL-
MIB
CISCO-PRODUCTS-MIB
CISCO-PROCESS-MIB
CISCO-RTTMON-MIB
CISCO-SMI-MIB
CISCO-STP-EXTENSIONS-MIB
CISCO-SYSLOG-MIB
CISCO-TC-MIB
CICSO-TCP-MIB
IF-MIB
INET-ADDRESS-MIB
OLD-CISCO-CHASSIS-MIB
OLD-CISCO-FLASH-MIB
OLD-CISCO-INTERFACES-MIB
OLD-CISCO-IP-MIB
OLD-CISCO-SYS-MIB
OLD-CISCO-TCP-MIB
OLD-CISCO-TS-MIB
RFC1213-MIB
RMON-MIB
RMON2-MIB