Technical Manual

PAGE
DES
TN 115 01 configuration for TNB 115, B channel
1
TYPE TIE type of trunk − TIE, could be DID ...,
see LD 14
CDEN SD default − card port density − single
density
CUST 0 Customer number − 0 get operator
"x", 1 get "Y", ...
NCOS 0 Network Class Of Service group − 0,
change if trouble calling in or out
RTMB 115 1
Route Number and Member Number
− member 1, could be 2...23, of route
block number 115
B−CHANNEL
SIGNALING
TGAR 1 Trunk Group Access Restriction −
0−31, 1 in this case
AST NO default − Associated Trunk for CTI
trunk monitoring and control? − no
IAPG 0 default − Event Group for USM
message 0−15
CLS CTD DIP WTA
LPR APN THFD HKD
default − Class of Service:
P10 VNL
CTD − Conditionally Told Denied
DIP − Dial Pulse
WTA − Warning Tone Allowed
LPR − Low Priority
APN − ACD Priority Not Required
THFD − Centrex Switchhook Flash
Denied
HKD − Hong Kong DTI Denied
P10 − 10 pulses per second
VNL − Via Net Loss, see LD14
TKID default − Trunk Identifier − like to
refernce a circuit ID
DATE 14 JUN 2000
default − date of this report
NACT ****
type **** to exit overlay module 20