Technical Manual

Requirements
There are no specific requirements for this document.
Configure
In this section, you are presented with the information to configure the features described in this document.
This trunk was configured for a test scenario. The extension for the IP phone was x7373 and for the digital
phone was x6925. When you called the IP phone from the digital phone, the access code 8815 was first dialed
to choose the specific PRI trunk (see ACOD 8815 in LD21), and then the extension of the IP phone was
dialed. For this test, the configuration allowed a number to be chosen for the IP phone that can be uniquely
routed.
Note: Use the Command Lookup Tool (registered customers only) to obtain more information on the
commands used in this section.
Configurations
This document uses these configurations:
D Signaling Channel Configuration
Configuration
Parameters
Comments
>LD 22 load overlay module 22 to print an i/o
device report PT2000
REQ PRT
@ Request prompt, enter "PRT" to print
TYPE ADAN DCH
8
@ Type prompt, enter:
"ADAN" for all i/o devices
"DCH" to specify D−channel devices
"8" to for the D−channel with ID #8
ADAN DCH 8
configuration for i/o D−channel 8
CTYP MSDL
card type − Mutiple Serial Data Link
GRP 1
System group − 1
DNUM 12
i/o device number − 12
PORT 3
physical port − 3
DES CISCO
description
USR PRI
D channel − PRI only
DCHL 115 the PRI card − aka "loop" − the channel is
for
OTBF 32
default − 32 output request buffers