Manual

tai mcc <mcc_id> mnc <mnc_id> tac <tac_code1> <tac_code2> <tac_code3>
exit
end
Notes:
•
<mme_pool_name> is a string of size 1 to 63, which configures a specified MME pool.
•
<mme-name> is a string of size 1 to 63, which configures a specific MME.
•
<ipv4_addr> is the remote SCTP IP address for S1 association to configured MME.
•
<sctp_port_no> is the SCTP port which is an integer ranging from 1 to 65535.
•
<lte_policy_tai_db> is the tracking area information list database, which must be a string of size 1 to
64.
•
<mcc_id> is a three digit number between 100 to 999.
•
<mnc_id> is two/three digit number between 00 to 999
•
<tac_code1> is the tracking area code value ranging as a integer from 0 ... 65535. Up to 256 can be
defined on one line.
Verifying HeNB-GW Configuration
This section shows the configuration parameters configured for HeNB-GW service.
Step 1
Verify that your HeNB-GW services were created and configured properly by entering the following commands in Exec
Mode:
show henbgw-access-service name <henbgw_access_svc_name>}
show henbgw-network-service name <henbgw_network_svc_name>}
The output of these command display concise listing of HeNB-GW Access and Network service parameter settings as
configured on system.
Step 2
Verify configuration errors of your HeNB-GW services by entering the following command in Exec Mode:
show configuration errors section henbgw-network-service}
The output of this command displays current configuration errors and warning information for the target configuration
file as specified for HeNB-GW Network service
Logging Facility Configuration
Use the following example to configure the HeNB-GW system to enable the logging and debug facilities for
HeNB-GW subscriber and related protocols.
HeNB-GW Administration Guide, StarOS Release 19
52
HeNB-GW Service Configuration Procedures
Verifying HeNB-GW Configuration