Manual

CHAPTER 3
HeNB-GW Service Configuration Procedures
This chapter is meant to be used in conjunction with the other chapters that describes the information needed
to configure the system to support HeNB-GW functionality for use in HeNB access networks.
It is recommended that you identify the options from the previous chapters that are required for your specific
deployment. You can then use the procedures in this chapter to configure those options.
At least one packet card must be made active prior to service configuration. Information and instructions
for configuring the packet cards to be active can be found in the Configuring System Settings chapter of
the System Administration Guide.
Important
While configuring any base-service or enhanced feature, it is highly recommended to take care of conflicting
or blocked IP addresses and port numbers for binding or assigning. In association with some service
steering or access control features, like Access Control List configuration, use of inappropriate port number
may result in communication loss. Refer respective feature configuration document carefully before
assigning any port number or IP address for communication with internal or external network.
Caution
This chapter includes the following:
•
Information Required to Configure the System as an HeNB-GW, page 40
•
HeNB-GW Service Configuration, page 46
•
Logging Facility Configuration, page 52
•
Alarm and Alert Trap Configuration, page 53
•
SNMP MIB Traps for HeNB-GW Service, page 54
•
Event IDs for HeNB-GW Service, page 55
•
DHCP Configuration, page 56
HeNB-GW Administration Guide, StarOS Release 19
39