Manual

Sample L2 Interchassis HA Configuration
▀ SecGW VM Configuration (StarOS)
▄ SecGW Administration Guide, StarOS Release 17
128
chassis-mode primary
hello-interval 3
configuration-interval 60
dead-interval 15
checkpoint session duration non-ims-session 30
route-modifier threshold 10
priority 10
monitor hsrp interface GigabitEthernet0/0/0/18.<srp_monitor_hsrp_vlan_ID>
afi-type IPv4 hsrp-group <srp_hsrp-group_number>
peer-ip-address <srp_peer_IPv4-address>
bind address <srp_bind_IPv4-address>
#exit
interface icsr
ip address <srp_interface_icsr_IPv4-address_mask_per_CPU-VM>
#exit
subscriber default
exit
aaa group default
#exit
ip route <srp_iproute_IPv4-address_mask> <srp_iproute_IPv4-address> icsr
#exit
connectedapps
sess-userid cisco
sess-passwd encrypted password <encrypted_password>
sess-name hsrp
sess-ip-address <connectapps_session_IPv4-address>
rri-mode BOTH
ha-chassis-mode inter
ha-network-mode L2
ca-certificate-name test
activate
#exit
wsg-lookup
priority 1 source-netmask 32 destination-netmask 32
priority 2 source-netmask 128 destination-netmask 128
priority 3 source-netmask 64 destination-netmask 64
#exit
port ethernet 1/10
no shutdown
vlan <port_1/10__vlan_id>
no shutdown
bind interface ike wsg
#exit
#exit
port ethernet 1/11
no shutdown
vlan <port_1/11_vlan_id_srp>
no shutdown
bind interface icsr srp
#exit
vlan <port_1/11_vlan_id_wsg>