Instruction manual

Hardware and Endpoints
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Page 80 ITP and SIP Feature Exceptions
ITP and SIP Feature Exceptions
Some endpoints cannot fully support certain features due to hardware or software restrictions.
These exceptions are listed below by endpoint type.
Model 8600: The Model 8600 endpoint operates in ITP or SIP mode. However, it does not
support the following features (feature code) in either mode:
• Feature Button Default (395)
• Microphone Mute On/Off (314)
• Program Buttons (397)
• Review Buttons (396)
• Switch Keymap (399)
Model 8690: The Model 8690 endpoint operates in ITP or SIP mode. However, the endpoint
does not support the following features (feature code) in either mode:
• Change Language (301)
• Feature Button Default (395)
• LCD Contrast Control (303)
• Program Buttons (397)
• Review Buttons (396)
• Switch Keymap (399)
Models 8664, 8665, and 8668: The Model 8664, 8665, and 8668 wireless IP endpoints operate
in ITP mode. However, they do not support the following ITP features (feature code):
• Automatic Intercom Access On/Off (361)
• Automatic Line Access On/Off (360)
• Background Music On/Off (313)
• Change Language (301)
• Group Listen (312)
• Handsfree On/Off (319)
• Headset On, Headset Off, Headset On/Off (315, 316, 317)
• LCD Contrast Control (303)
• Page Receive On/Off (325)
• Switch Keymap (399)
Model 8601: The Model 8601 operates in SIP mode only. However, it does not support the fol-
lowing SIP features (feature code):
• Headset On, Headset Off, Headset On/Off (315, 316, 317)
• LCD Contrast Control (303)
• Show IP Address (300)