Instruction manual

Administrator Procedures
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Speed Dial Names
Page 51
Table 9 shows the dialpad equivalents for English/Spanish and for Japanese language charac-
ters. Japanese characters are included in your standard software license and can be pro-
grammed as the Primary or Secondary Language.
* Japanese characters are available only if the Multilingual feature is enabled and Japanese is
installed as the secondary language.
To program or change System Speed Dial numbers and names:
1. While on-hook, enter the Program System Speed Dial feature code (9801). Display end-
points show
PROGRAM SYS SPD # (000–999).
2. Enter the Speed Dial location code (000–999). The display shows ENTER NAME: <cur-
rent name>
. If you do not continue to the next step, the display times out after the Long
Inter-digit timer expires and you must start over.
3. Perform the following actions, as needed:
a. To change or program the name:
Using your dialpad as described on page 50, type the name for the Speed Dial
number you want, and then press or
ACCEPT. See Table 9, above.
If you make a mistake, use the button to back up and erase existing charac-
ters or the
CLEAR button to erase the whole entry.
b. To erase the current name and leave it blank:
Press
CLEAR or press repeatedly until the name is erased, and then press
or
ACCEPT.
c. To leave the name the same:
Press or
ACCEPT.
Table 9.
Alphanumeric Equivalents for Dialpad Programming
Number of Times Button is Pressed
Button 1 2 3 4 5 6 7 8 9 10 11
ENGLISH/SPANISH
CHARACTERS
KATAKANA CHARACTERS
*
1 -&( ) 1A I U E O a
2 ABC ’ 2
KA KI KU KE KO i
3 DEF ! 3
SA SHI SU SE SO u
4 GH I * 4
TA CHI TSU TE TO e
5 JKL# 5
NA NI NU NE NO o
6 MNOÑ 6
HA HI FU HE HO tsu
7 PQRS 7
MA MI MU ME MO ya
8 TUV? 8
YA YU YO . , yu
9 WXY Z 9
RA RI RU RE RO yo
0 @: . , 0
WA WO N pa ba long
#
MUTE
MUTE
#
#