Instruction manual

ManualsBrandsCisco ManualsComputer equipmentCisco ASR 5000 Application Detection and Control Administration Guide

Administrator Procedures

INTER-TEL

5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007

Trunk Programming

Page 45

5. To Program A Trunk Group: Press or the TRUNK GROUP menu button. Then

program the trunk group, as follows:

• The display shows

ENTER TRUNK GRP EXTENSION. Enter the extension num-

ber of the trunk group to be programmed using one of the methods described on

page 43.

• The display shows

ENTER TRUNK GROUP OPTION. Select one of the following

options. To view the last three options on a display endpoint, press the arrow (

or >>) menu button at the bottom of the display.

– Answer Access For Day Or Night Mode: To program the endpoint(s) that

will have answer access for this trunk group for day mode, press or the

ANS-ACCESS DAY menu button. To program for night mode, press or

the

ANS-ACCESS NIGHT menu button. When the display shows ENTER

ENDPOINT EXTENSION

, perform the procedure described below.

a.) Enter an endpoint extension using one of the methods described on

page 43.

b.) The display shows the extension number and a Yes/No prompt. To

include the endpoint in the list, press or the

YES menu button, fol-

lowed by . Or, to exclude the endpoint from the list, press or the

NO menu button, followed by .

c.) When the display returns to ENTER ENDPOINT EXTENSION, select

another extension number. Or, if finished programming the endpoint list,

press or

ACCEPT to continue.

– Ring-In For Day Or Night Mode: To program the endpoint that will have

ring in for this trunk group for day mode, press or the

RING-IN DAY

menu button. To program for night mode, press or the RING-IN NIGHT

menu button. When the display shows ENTER ENDPOINT EXTENSION,

enter endpoints into the list one at a time as described above for Answer

Access.

– Toll Restriction: To program the toll restrictions for the trunk group, press

or the

TOLL RESTRICTION menu button. When the display shows TOLL

RESTRICTION OPTION

, press the numbers that correspond to the toll

restrictions you want to program, as follows:

a.) COS for day or night mode: To program the toll restriction class of ser-

vice for day mode, press or the

COS DAY menu button. To program

class of service for night mode, press or the

COS NIGHT menu but-

ton. The display shows

SET DAY (or NIGHT) COS XX. If this is not the

COS you want to program, scroll to the correct COS by pressing the high

end of the

Volume button or the NEXT menu button to scroll forward, or

press the low end of the

Volume button or the PREVIOUS menu button to

scroll backward. The default COS numbers are listed below. For defini-

tions, see “Class of Service” on page 143. COS 01 is not used for trunks.

When the correct COS is displayed, press or the

ON menu button to

enable the toll restriction. Or, press or the

OFF menu button to disable

it. Repeat this step to program additional COS toll restrictions, and then

press or

ACCEPT to continue.