Instruction manual

ManualsBrandsCisco ManualsComputer equipmentCisco ASR 5000 Application Detection and Control Administration Guide

Administrator Procedures

INTER-TEL

5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007

Trunk Programming

Page 43

Trunk groups:

• Day/Night Answer Access: You can program separate lists for endpoints with allowed-

answer access in day and night modes.

• Day/Night Ring-In: You can program separate lists of endpoints with ring-in for day

and night modes.

• Change Toll Restrictions: You can program toll restriction classes of service for the

trunk groups. Classes of service are described in detail on page 143.

• Trunk List: Each trunk group has a programmed list of individual trunks.

The Trunk Database Programming process is summarized in the flowchart shown on page 48.

See page 309 for Program Planning Sheets.

If necessary, at any time during the following procedure you can press the asterisk ( ) or

Speaker button to cancel programming and discard any unsaved changes.

Entering extension numbers:

When the procedure asks you to enter an endpoint, trunk, or trunk group extension number,

you can use any of the following methods. (If you enter an invalid extension number, you hear

reorder tones and must try again.)

• Enter a complete number: Enter the extension number using your dialpad. When the

circuit information is displayed, press again to continue.

• Enter a partial number: Enter a partial extension number then press , the high end

of the

Volume button, or the menu button. The display shows the extension number,

username and circuit number of the endpoint, trunk, or trunk group that most closely

matches the partial extension number. Press or

ACCEPT to accept the displayed

extension, or scroll to another endpoint as described below.

• Scroll through the numbers: To scroll through the extension number list, press the

high end of the

Volume button or the NEXT menu button to scroll forward, or press the

low end of the

Volume button or the PREVIOUS menu button to scroll backward. When

the correct extension number is displayed, press or

ACCEPT to continue.

To program trunk information:

1. While on-hook, enter the Program Database feature code (9932) [9132 in Europe].

2. If a password is required, the display shows ENTER PASSWORD. Use the dialpad to

enter your 1–8 digit password and press . (If you enter an incorrect password, the

display shows

INVALID PASSWORD.)

If a password is not required, skip this step.

3. The display shows ENTER DATABASE OPTION. Six-line display endpoints also show

the following options:

ENDPOINT, SYSTEM, and TRUNK. Press or the TRUNK

menu button. The display shows ENTER TRUNK OPTION.