Instruction manual

Administrator Procedures
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
System Database Programming Flowchart
Page 41
Figure 2. System Database Programming Flowchart
Enter the extension
number of the end-
point to be changed
Enter Program Database
feature code 9932 [9132]
Press 2 or SYSTEM menu button
ENTER DATABASE OPTION
Press 2 or
PASSWORD
menu button
Enter the new
message using alpha
or numeric mode
ENTER SYSTEM OPTION
Enter message
number or select
DND message to
Press 1 or
DND MESSAGES
menu button
Press 4 or
STN EXTENSIONS
menu button
Press 1 or
CHANGE EXT
menu button
SELECT DND
If wanted, select
another message
(DND message)
SCROLL OR EDIT
Enter the new
CHANGE
VERIFY
Enter the new
message using alpha
or numeric mode
Enter message
number or select
message to program
SELECT
If wanted, select
another message
(Reminder message)
SCROLL OR EDIT
Enter the new
extension number
and press #
ENTER ENDPOINT
CHANGE (number)
SCROLL OR EDIT
Enter 0-8 digit
password and
password again
EXTENSION
MESSAGE
program by scrolling
and press #
to program
PASSWORD
press #
PASSWORD
and press #
REMINDER MSG
by scrolling
and press #
to program
for the endpoint
Enter the extension
number of the second
and press #
Enter the extension
ENTER ENDPOINT
SWAP (extension)
WITH EXTENSION
EXTENSION
number of the first
endpoint to be swapped
endpoint to be swapped
Press 2 or
SWAP EXTS
menu button
Press 3 or
REMINDER MSGS
menu button
and press #
YOUR INPUT
ENDPOINT DISPLAYS
AT ANY LEVEL:
Press * or the Speaker button to cancel any un-
saved changes and back up to exit program-
ming.
Press # or ACCEPT to save changes and back
up one display level.
INFORMATION IN THIS CHART IS SHOWN
AS FOLLOWS: