Instruction manual

Administrator Procedures

INTER-TEL

5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007

Page 34 Station Programming

The default COS numbers for the U.S. are provided in Table 6 and the

default COS numbers for Europe are provided in Table 7.

a.) When the correct COS is displayed, press or the ON menu button to

enable the toll restriction. Or, press or the

OFF menu button to disable

it.

b.) If necessary, repeat the option titled “Toll Restriction” on page 33, and

then to program additional COS toll restrictions, repeat step a above.

c.) Press or ACCEPT to save the COS programming. The display shows

DATABASE UPDATED and then returns to the TOLL RESTRICTION

OPTION

prompt.

d.) Press again to exit to the ENTER ENDPOINT OPTION prompt.

6. When the display shows ENTER ENDPOINT OPTION, press again to exit to the

ENTER ENDPOINT EXTENSION prompt. You can then program another endpoint by

repeating these steps or press or

ACCEPT once more to exit to the ENTER DATA-

BASE OPTION

prompt.

7. When finished with all programming, press while the ENTER DATABASE OPTION

prompt is displayed. This ends the programming session.

8. If a system reset is required, the display shows ENTER SYS RESET OPTION. Do one

of the following:

– Delayed Reset: Press or the

DELAYED menu button to delay the reset. The dis-

play shows

DELAYED RESET SCHEDULED. The system will be reset at the pre-

programmed time.

– Immediate Reset: Press or the

IMMEDIATE menu button to reset the system now.

Table 6. Default Class of Service (COS) Numbers for the U.S.

COS 02 – Deny Area/Office COS 06 – Deny Equal Access

COS 03 – Deny Operator COS 07 – Deny Local Calls

COS 04 – Deny Toll Access COS 08 – Denied Numbers

COS 05 – Deny International COS 09 – Allowed Numbers

Table 7. Default Class of Service (COS) Numbers for Europe

COS 01 – ARS Only COS 05 – Deny Local Calls

COS 02 – Deny Operator COS 06 – Denied Numbers

COS 03 – Deny Toll Access COS 07 – Allowed Numbers

COS 04 – Deny International

NOTICE

Possible interruption of calls in progress. When the system is Reset, all calls in

progress are dropped immediately.