Instruction manual

ManualsBrandsCisco ManualsComputer equipmentCisco ASR 5000 Application Detection and Control Administration Guide

Administrator Procedures

INTER-TEL

5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007

Station Programming

Page 33

5. The display shows ENTER ENDPOINT OPTION. Select one of the following:

• Endpoint Flags: This option allows you to set the administrator endpoint, atten-

dant, and House Phone flags. To select it, press or the

ENDPOINT FLAGS

menu button. Three flags can be programmed: Administrator, Attendant, and

House Phone. However, you cannot program the Administrator flag for your own

endpoint or for a single line endpoint. To program the flags, do the following:

– To scroll to the wanted flag, press the high end of the Volume button or

NEXT to scroll forward, or press the low end of the Volume button or PREVI-

OUS

to scroll backward.

– To enable or disable a displayed flag, press or the

ON menu button to

enable the flag. Or, press or the

OFF menu button to disable the flag.

– To save your programming when all flags are set correctly, press or

ACCEPT to save the new flag settings. The display shows DATABASE

UPDATED

and then returns to the ENTER ENDPOINT OPTION prompt.

– To exit without saving your changes, press or

CANCEL to exit. The dis-

play shows

NO UPDATE PERFORMED and then returns to the ENTER END-

POINT OPTION

prompt.

• Endpoint Information: This option allows you to select an attendant for the end-

point or program the endpoint’s username. To select it, press or the

ENDPOINT

INFO

menu button. The display shows ENTER ENDPOINT INFO OPTION. Select

one of the following:

– Attendant: To assign an attendant to serve this endpoint, press or the

ATTENDANT menu button. The display shows ENTER ATTENDANT

EXTENSION

. Enter the extension number you want. When the circuit infor-

mation is displayed, press again to return to the

ENTER ENDPOINT INFO

OPTION

prompt. The display shows DATABASE UPDATED. (Or, to cancel

your entry, press or

CANCEL. The display shows NO UPDATE PER-

FORMED

– Username: To change the username of the endpoint, press or the

USER-

NAME

menu button. The display shows ENTER USERNAME. Enter the new

name as described on page 31. To cancel your entry, press or

CANCEL.

The display shows

NO UPDATE PERFORMED.

• Toll Restriction: This option allows you to set the endpoint class of service for

day and/or night modes. To select it, press or the

TOLL RESTRICTION menu

button. Then do the following:

– The display shows

TOLL RESTRICTION OPTION. Press or the COS DAY

menu button to program day mode toll restriction. Or, press or the COS

NIGHT

menu button to program night mode toll restriction.

– The display shows

SET DAY (or NIGHT) COS XX. If this is not the COS you

want to program, scroll to the correct COS by pressing the high end of the

Volume button or

NEXT to scroll forward, or press the low end of the Vol-

ume button or

PREVIOUS to scroll backward. For more information about

COS, see page 143.