Instruction manual

Reference
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Page 322 Administrator Feature Codes
Administrator Feature Codes
Table 52 summarizes feature codes accessible only on administrator endpoints. Non-adminis-
trator endpoints produce reorder/fast-busy tones if these feature codes are keyed into them.
Transfer to Hold 346 Transfers a call to another endpoint and
places it on individual hold so that it does not
ring or send call waiting signals until it recalls.
Transfer to Ring 345 Transfers a call to another endpoint or to an
outside phone number.
Table 51. Endpoint Feature Codes (Continued)
Feature Name Code Definition
Table 52. Administrator Feature Codes
Feature Name
Code
U.S. [Europe]
Definition
Clear Network Alarm 9851 Clears network-wide alarms on every node
in the network, but will not affect system
alarms. The Clear Network Alarm feature
code may be entered on any node in the
network, but the Send Network Alarms flag
must be set for the administrator to clear
alarms on other nodes in the network.
Clear System Alarm 9850 Clears all local and network-wide system
alarm displays on your node.
Diagnostics On/Off 9900
[9100]
Enables or disables system diagnostics
mode to perform diagnostics functions such
as freezing/unfreezing the database, print-
ing message logs, and seizing a device for
troubleshooting purposes.
Enable Network Day 9862 Places any or all remote nodes into day
mode (you are prompted for the node num-
ber).
Enable Network Night 9861 Places any or all remote nodes into night
mode (you are prompted for the node num-
ber).
Modem Disable 9867 Disables the internal modem; used in con-
junction with the assigned extension num-
ber of the modem.
Modem Enable 9866 Enables the internal modem; used in con-
junction with the assigned extension num-
ber of the modem.
IMPORTANT
Because diagnostics
mode affects system
performance, it is rec-
ommended that you run
the diagnostics program
when the system is idle.