Instruction manual

Reference
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Endpoint Feature Codes
Page 321
Reminder Message
Reminder Message Cancel
305
306
(Not used on single line endpoints) The end-
point user can set reminder messages that
signal the endpoint at specific times. Or, the
user can cancel all reminder messages for the
endpoint.
Remote Programming 359 Allows a user to place an endpoint in DND
mode, forward the endpoint’s calls, or change
the password; either from another endpoint or
through DISA.
Reverse Transfer (Call Pick-Up) 4 Picks up a call ringing or holding at an end-
point or hunt group
Review Keys 396 (Not used on single line endpoints) User-pro-
grammable feature buttons and Station Speed
Dial buttons can be viewed using this feature
code.
Ring Intercom Always On/Off 377 Enables/disables the feature that allows the
endpoint to always place private (non-hands-
free) intercom calls.
Ring Tone Selection 398 (Not used on single line endpoints) Selects
the type of ringing alert tone that will be heard
from the endpoint.
Routing Off 304 Disables System OAI Offering Control for
third-party applications. This feature requires
you to enter a password. Once you disable
routing, you cannot enable it again (i.e., only
the third-party application can enable routing).
Station Monitor 321 (Hunt Group supervisors only) Allows a desig-
nated hunt group supervisor to monitor a call
of anyone in the associated hunt group.
Station Speed Dial
Station Speed Dial Programming
382
383
Dials/programs one of the 10 Station Speed
Dial numbers when followed by a location
code (0–9). Inter-Tel endpoints use the Station
Speed Dial button plus a location code for pro-
gramming and dialing, or they can program
Speed Dial buttons for one-button dialing.
Steal 387 Allows the supervisor to take away a call from
the hunt group member/agent.
Switch Keymap 399 (Not used on single line endpoints) Allows an
endpoint user to switch between standard and
alternate keymaps.
System Forward Enable
System Forward Disable
System Forward On/Off
352
353
354
Enables or disables the database-pro-
grammed System Forwarding feature for this
endpoint. The on/off feature code can be used
to toggle the feature on or off.
System Speed Dial 381 Dials one of the 1000 System Speed Dial
phone numbers when followed by a location
code (000–999). Also used for reviewing Sys-
tem Speed Dial numbers.
Table 51. Endpoint Feature Codes (Continued)
Feature Name Code Definition