Instruction manual

Reference
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Page 320 Endpoint Feature Codes
Message – Silent 367 Leaves a Message Waiting indication at an
endpoint without first placing an intercom call.
Mute On/Off 314 (Not used on single line endpoints) Turns the
microphone on or off during a call. If muted,
the endpoint user can hear the other party, but
the party cannot hear the endpoint user.
(Inter-Tel endpoints can also use the MUTE
button.)
Page 7 When followed by a paging zone code (0–9 or
0–49), it allows announcements to be made
through endpoint speakers and any external
paging speakers in the page zone.
Page On/Off 325 (Not used on single line endpoints) Halts
pages through the endpoint speaker or allows
them to be received again.
Program Buttons 397 (Not used on single line endpoints) User-pro-
grammable feature buttons and Station Speed
Dial buttons can be programmed using this
feature code.
Program Endpoint Password 392 The endpoint password is used for the
Remote Programming feature. The password
can be changed by entering the Program End-
point Password feature code at the endpoint
or when using the Remote Programming fea-
ture.
Queue Request 6 Requests (or cancels) an automatic callback
when a busy trunk or endpoint becomes avail-
able.
Record-A-Call 385 If the system is programmed with a Record-A-
Call application, the endpoints can be pro-
grammed to use the Record-A-Call feature. It
allows users to enter a feature code whenever
they want to record an ongoing call in their
designated Record-A-Call mailbox. Users can
retrieve the recorded messages later, just as
they would any other mailbox messages.
Redial 380 Redials the last outside phone number dialed
or saved at the endpoint (up to 48 digits). Also
used to save numbers at endpoints pro-
grammed for last number saved. (Inter-Tel
endpoints use the REDIAL button.)
Redirect Call 331 Allows the endpoint user to route ringing out-
side, intercom, and camped on calls to
another endpoint, hunt group, or outside num-
ber. Routing of the redirected call is still sub-
ject to trunk and toll restrictions. This feature
provides these options in addition to the cur-
rently available options which allow the end-
point user to redirect calls to Voice Mail or Do-
Not-Disturb. The Redirect Ringing Call feature
does not require any premium features.
Table 51. Endpoint Feature Codes (Continued)
Feature Name Code Definition