Instruction manual

Reference
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Endpoint Feature Codes
Page 319
Group Listen 312 (Not used on single line endpoints) Allows a
user to transmit a conversation over the end-
point speaker while in handset or headset
mode.
Handsfree On/Off 319 (Not used on single line endpoints) Disables/
enables the endpoint’s handsfree intercom
answering. Incoming intercom calls ring as pri-
vate calls if handsfree answering is disabled.
Headset Enable
Headset Disable
Headset On/Off
315
316
317
(Not used on single line endpoints) The
enable code signals the system that a headset
has been connected to the endpoint. The dis-
able code returns the endpoint to normal oper-
ation. The on/off feature code can be used to
toggle the feature on or off.
Hold – Individual 336 Places a call on hold so that it can be picked
up directly at that endpoint or through a
reverse transfer from any other endpoint.
(Inter-Tel endpoints use the HOLD button.)
Hold – System 335 Places an outside call on system hold. It can
be picked up directly at any endpoint that has
an individual trunk button and has allowed-
answer and/or outgoing access for that trunk,
or by the endpoint that placed it on hold. (If
used on conference or intercom calls, the sys-
tem places the call on individual hold.)
Hunt Group Remove
Hunt Group Replace
Hunt Group Remove/Replace
322
323
324
Removes the endpoint from its assigned hunt
group(s) or places it in again. Does not affect
non-hunt group calls. The remove/replace fea-
ture code can be used to toggle the feature.
LCD Contrast Adjustment 303 (Model 8620/8622, 8660, or 8662) Adjusts the
LCD contrast on the display. The endpoint
must be idle to use this feature.
Message 365 This feature code is used for leaving and
retrieving a message waiting indication at a
called endpoint or the called endpoint’s mes-
sage center. Depending on how the message
was left, the called endpoint user either
retrieves the message from his/her message
center or from the endpoint that left the mes-
sage. (Inter-Tel endpoints use the MSG but-
ton.)
Message – Cancel 366 Allows the endpoint user to cancel a message
waiting indication that he or she left at another
endpoint.
Message – Cancel Current 368 Cancels a message waiting indication that is
waiting at the endpoint without requiring the
user to respond to it. (Inter-Tel endpoints can
use the asterisk [*] button while viewing the
message.)
Table 51. Endpoint Feature Codes (Continued)
Feature Name Code Definition