Instruction manual

Reference
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Page 318 Endpoint Feature Codes
Default Endpoint 394 This single feature code cancels account
codes for all calls following, Do-Not-Disturb,
manual call forwarding, background music,
ring intercom always, and queue requests;
restores handsfree mode, pages, hunt group
calls, and system forwarding; and returns end-
point volumes to default values.
Directories 307 (Display endpoints Only) Allows display end-
point users to search for extension numbers
or System Speed Dial numbers. The number
can then be dialed, if appropriate.
Display Outside Party Name
On/Off
379 (Display endpoints Only) When the endpoint
user enters this feature code, while connected
to a CO call that has outside party name infor-
mation, the display will toggle between the
caller’s name and number. If there is no out-
side party name or the Expanded CO Call
Information On Displays flag is disabled, the
user will hear a burst of reorder tone and see
the CANNOT ACCESS FEATURE display. If
the Display Outside Party Name On/Off fea-
ture code is programmed in a user program-
mable button with a lamp, the lamp will be lit
when the outside party name is enabled and
off when the outside party number is enabled.
Display Time/Date (ITP)
Show IP Address (SIP)
300 (Display endpoints Only) Temporarily displays
the system date and time, username, and
extension number during a call or when other
displays are shown.
Feature code 300 displays the IP Address of
an endpoint if it is in SIP mode.
Do-Not-Disturb
Do-Not-Disturb Cancel
Do-Not-Disturb On/Off
370
371
372
The Do-Not-Disturb feature code halts all
intercom calls, transferred calls, and pages to
the endpoint. The Cancel code returns the
endpoint to normal operation. The on/off code
can be used to turn Do-Not-Disturb on or off.
(Inter-Tel endpoints use the DND button.)
Do-Not-Disturb Override 373 (Not used on single line endpoints) If enabled
in the database, allows the endpoint user to
break through another endpoint’s Do-Not-Dis-
turb mode when placing an intercom call.
Enhanced Speakerphone Enable 310 (Digital endpoints only) When entered at a
digital endpoint, this feature code enables the
enhanced speakerphone as described in “Dis-
play and Nondisplay Digital Endpoints” on
page 98. Digital endpoints can also use the
Special button + Speaker buttons.
Feature Key Default 395 (Not used on single line endpoints) Endpoints
have user-programmable feature buttons that
can be set to enter feature codes. This code
returns the user-programmable buttons to the
database default values.
Table 51. Endpoint Feature Codes (Continued)
Feature Name Code Definition