Instruction manual

Reference
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Default Feature Codes
Page 315
Default Feature Codes
Each of the station features is assigned a feature code. Using the station’s dialpad, these codes
are entered to select trunks, process calls, and use special features. The following tables show
default feature code values:
• Table 50 on this page.
• Table 51 on page 316.
• Table 52 on page 322.
• Table 53 on page 324.
Trunk Access Codes
These feature codes are used to select trunks when placing outgoing calls.
Table 50.
Trunk Access Codes
Feature Name
Code
U.S. [Europe]
Definition
Automatic Route Selection
(ARS)
92000 Allows the system to select the route wanted
for placing a call, as programmed in the data-
base.
Trunk Group Access 1–208 92001–92208 Selects an available trunk from a pro-
grammed group of trunks for placing an out-
side call.
Emergency Call 911
[999 or as
applicable]
Entering this feature code selects an outgo-
ing trunk and automatically dials the pro-
grammed Emergency Call number, which is
routed by default out Trunk Group 1.
Outgoing Call 8 Selects an outgoing trunk according to the
programmed outgoing access mode for that
endpoint. Inter-Tel endpoints use the OUT-
GOING button or a Call button.