Instruction manual

System Features
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Remote Do-Not-Disturb Programming
Page 243
Should the verified password and new password not match, the old password will be retained
and the programming session canceled.
To change the station password from your station:
1. Enter the Program Station Password feature code (392). You hear a confirmation tone.
If you have a display, it shows
ENTER PASSWORD.
2. Enter your current password, followed by #. (At default, it is your extension number.) If
you have a display, it shows
NEW PASSWORD.
If you enter an incorrect password, the display will show INVALID PASSWORD, and
your endpoint will return to the idle state.
3. Enter the new password followed by . You hear a confirmation tone.
4. Enter the new password again for verification followed by . You hear a confirmation
tone. If you have a display, it shows
PASSWORD SAVED. Your station returns to idle.
To change the endpoint password using remote programming:
1. If calling from an outside endpoint, access the system through a DISA line. Enter the
DISA security code (if applicable). You hear a confirmation tone.
If programming from another endpoint, lift the handset or press the Speaker button.
2. Enter the Remote Programming feature code (359). You hear a confirmation tone. If
you have a display, it shows
ENTER EXTENSION. Users of Executive and Professional
Display endpoints and Model 8560 endpoints can press the
IC DIR button to use the
intercom directory to look up a number.
3. Enter the extension to be programmed. You hear a confirmation tone. If you have a dis-
play, it shows
ENTER PASSWORD. If you entered an invalid extension number, you
will hear reorder tones and can try again.
4. Enter the extension’s password followed by . You hear a confirmation tone.
If you enter an incorrect password, the display will show
INVALID PASSWORD. Out-
side callers will be returned to dial tone, and stations will return to the idle state.
5. Enter the Program Station Password feature code (392). You hear a confirmation tone.
If you have a display, it shows
NEW PASSWORD.
6. Enter the new password, followed by . You hear a confirmation tone.
7. Enter the new password again for verification, followed by #. You hear a confirmation
tone. If you have a display, it shows
PASSWORD SAVED. Outside callers will hear dial
tone, and endpoint return to the idle state.
Remote Do-Not-Disturb Programming
After each entry, non-display endpoint users will hear a confirmation tone. Outside callers
using a DISA line will hear confirmation tone followed by DISA dial tone. Display endpoint
users will not hear confirmation tones but will see a prompt asking for the next entry.
To place a station in Do-Not-Disturb mode using the remote programming feature:
1. If calling from an outside endpoint, access the system through a DISA line. Enter the
DISA security code, if applicable. You hear a confirmation tone followed by DISA dial
tone.
If programming from another station, lift the handset or press the Speaker button.
2. Enter the Remote Programming feature code (359). If you have a display, it shows
ENTER EXTENSION. Model 8660 or 8662 endpoint users can press the IC DIR button
to use the intercom directory to look up a number.
#
#
#
#