Instruction manual

System Features

INTER-TEL

5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007

Using the Last Number Saved Feature

Page 235

Using the Last Number Saved Feature

Use the following procedures to save and redial numbers at stations that are programmed to

use the Last Number Saved feature. The saved number is replaced each time you repeat this

procedure.

To save a number on a station programmed for last number saved:

Inter-Tel endpoints: While the endpoint is idle or while listening to intercom dial tone,

press the button, or press the Special button and enter the Redial feature code

(380). You hear a confirmation tone, and the display shows

LAST OUTSIDE NUMBER

SAVED

Single line endpoints: Lift the handset and enter the Redial feature code (380). When

you hear the confirmation tone, hang up.

To redial a number (last number saved):

Inter-Tel endpoints: While on a call or after selecting a trunk, press the button,

or press the Special button and enter the Redial feature code (380). See Table 31 on

page 234 to determine which trunk is selected. The saved phone number is dialed.

Single line endpoints: While on a call or after selecting a trunk, hookflash and then

enter the Redial feature code (380). See Table 31 on page 234 to determine which trunk

is selected. The saved phone number is dialed.

Using the Last Number Dialed Feature

Use the following procedure to redial numbers at stations that are programmed to use the Last

Number Dialed feature.

To redial a number (last number dialed):

Inter-Tel endpoints: While on- or off-hook, press the button, or press the Spe-

cial button and enter the Redial feature code (380). See Table 31 on page 234 to deter-

mine which trunk is selected and which digits are dialed.

Single line endpoints: Lift the handset or hookflash. Then enter the Redial feature code

(380). See Table 31 on page 234 to determine which trunk is selected and which digits

are dialed.

REDIAL