Manualshelf

Instruction manual

ManualsBrandsCisco ManualsComputer equipmentCisco ASR 5000 Application Detection and Control Administration Guide
241242243244245246247248249250
System Features
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Page 224 Dialing Station Speed Dial Numbers
Dialing Station Speed Dial Numbers
To dial a Station Speed Dial number at a single line endpoint:
1. Lift the handset. (Inter-Tel endpoints can remain on-hook.)
2. If placing an outside call, select an outgoing trunk or use ARS. If placing an intercom
call or if the outside number contains a trunk access code, skip this step.
3. Hookflash and enter the Station Speed Dial feature code (382). You hear a confirmation
tone. Then dial the location code (0–9). The number is dialed.
To dial a Station Speed Dial number at a non-display endpoint:
1. Lift the handset or remain on-hook.
2. If placing an outside call, select an outgoing trunk or use ARS. If placing an intercom
call or if the outside number contains a trunk access code, skip this step.
3. Inter-Tel endpoint with a Speed Dial button: Press the Speed Dial button of the num-
ber you want. The number is dialed.
Inter-Tel endpoint without a Speed Dial button: Enter the Station Speed Dial feature
code (382). You hear a confirmation tone. Then enter the location code (0–9). The num-
ber is dialed.
To dial a Station Speed Dial number at a display endpoint:
1. Lift the handset or remain on-hook.
2. If placing an outside call, select an outgoing trunk or use ARS. If placing an intercom
call or if the outside number contains a trunk access code, skip this step.
3. Inter-Tel endpoint with a Speed Dial button: Press the Speed Dial button of the num-
ber you want. The number is dialed. Display endpoints show the number.
Inter-Tel endpoint without a Speed Dial button: Enter the Station Speed Dial feature
code (382). Then do one of the following to dial the number:
• Use a location code: Dial the applicable Speed Dial location code (0–9).
• Scroll through the displayed numbers: Scroll to the number you want by press-
ing the Volume,
NEXT, or PREVIOUS button.
• Use the Executive or Professional Display or the Model 8560 endpoint menu:
Use the menu buttons to select the applicable Speed Dial location.