Instruction manual

System Features
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Page 210 System Forward Enable/Disable
System Forward Enable/Disable
The user can enter feature codes that disable or enable System Forward at that endpoint. This
flag does not affect the endpoint’s appearance on any other endpoint’s call forwarding path.
The flag only determines whether the endpoint will have its own calls System Forwarded.
To enable or disable system forwarding:
• Inter-Tel endpoints: Enter the System Forward On (352), System Forward Off (353),
or System Forward On/Off (354) feature code. The display shows
SYSTEM FORWARD
ON
(or OFF). If disabled, the system ignores any System Forward paths programmed
for this endpoint until System Forward is enabled.
• Single line endpoints: Lift the handset and enter the System Forward On (352), System
Forward Off (353), or System Forward On/Off (354) feature code. If disabled, the sys-
tem ignores any System Forward paths programmed for this endpoint until System For-
ward is enabled.