Instruction manual

ManualsBrandsCisco ManualsComputer equipmentCisco ASR 5000 Application Detection and Control Administration Guide

181

182

183

184

185

186

187

188

189

190

System Features

INTER-TEL

5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007

Page 164 Placing Intercom Calls

To receive an intercom call on a single line endpoint:

When you hear repeating double tones, lift the handset.

To receive a transferred-to-hold intercom call:.

Inter-Tel endpoints: If the endpoint does not have an button, the call will

appear under a Call button. When the button (or Call button) is fluttering and

the display shows <calling endpoint> TFR FROM <transferring endpoint>, lift the

handset and press the button (or Call button). Or, while on-hook, press the

button (or Call button) to speak handsfree. You are connected to the caller.

Executive Display, Professional Display, and Model 8560 endpoint users have the same

menu button options as described for a ringing intercom call.

Single line endpoints: When you hear a page announcing that a call is holding at your

endpoint, lift the handset (at your endpoint) and enter the Individual Hold feature code

(336). You are connected to the caller.

Placing Intercom Calls

When placing an intercom call, begin dialing before the Dial Initiation timer expires. If the

timer expires, the system drops the connection and sends reorder tones.

To place an intercom call:.

1. For all Inter-Tel endpoints:

To use the handset: Lift the handset. If the endpoint has a display it shows

ENTER

EXTENSION NUMBER

. If you want to place a private (non-handsfree) call to an Inter-

Tel endpoint, press the pound ( ) button before dialing the extension number.

To use the speakerphone: Skip to step 2 (begin dialing). The Speaker button lights.

The display shows

ENTER EXTENSION NUMBER.

Executive Display, Professional Display, and Model 8660 or 8662: Lift the handset

or begin dialing as described above. The display shows

ENTER EXTENSION NUMBER.

You may press one of the following menu buttons:

– IC DIRECTORY: Press this button to use the Intercom Directory feature. See

page 225 for instructions.

– OUTSIDE CALL: If you would rather make an outside call, press this button and

see the instructions on page 178.

Single line endpoints: Lift the handset. (If the DTMF decoders are busy, you hear

silence. Hang up and try again.)