Instruction manual

System Features
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Page 154 “DKTS Alternate Transient Display Timer” Endpoint Flag and Timer
“DKTS Alternate Transient Display Timer” Endpoint Flag and Timer
As an alternative to (or in addition to) disabling the call transfer and message transient dis-
plays, as previously described, the programmer can use a combination of an endpoint flag and
a timer to control all of the endpoints’ transient displays (not just the call transfer and message
displays). The “DKTS Alternate Transient Display Timer” endpoint flag, if enabled, allows all
transient displays to be controlled by the “DKTS Alternate Transient Display” timer.
The “DKTS Alternate Transient Display” timer can be set to 1–255 tenths of a second (0.1–
25.5 seconds). The default value is 10 tenths of a second (1 second). This timer affects only
those Inter-Tel endpoints with the “DKTS Alternate Transient Display Timer” flag enabled.
“Transient Call Indication On Call Answer” Endpoint Flag
This programmable endpoint flag determines whether the endpoint user sees a call display
when answering a call by pressing a secondary extension button or by reverse transferring. If
enabled, the display shows if the call was ringing, recalling, transferred, or holding at the other
endpoint.
User-Programmable Feature Buttons
This feature does not apply to single line endpoints.
Individual Inter-Tel endpoint buttons can be designated “user-programmable” in the keymaps
in DB Programming. The installer can program the default feature codes, and the endpoint user
can reprogram the feature codes as appropriate. Default endpoint feature codes are shown on
page 395. Up to 35 user-programmable endpoint buttons can be programmed to enter any of
the general feature codes.
Inter-Tel display endpoints have a special key if the buttons are in the default state.
However, it can be programmed to use any of the Forward feature codes. When the
button is pressed, the display shows a menu of call forwarding options. The user must then
select the appropriate option by pressing the corresponding button next to the display. If the
button is programmed to use any other Forward feature code (355–358), the forward-
ing options will not be displayed when the button is pressed. Any Inter-Tel endpoint
user can make any user-programmable button a button that uses any one of the for-
warding feature codes (355–358).
Secondary extension buttons, described on page 93, can be assigned to user-programmable but-
tons during keymap programming. If so, the endpoint user can determine the primary endpoint
that is associated with the secondary extension button by using the feature button programming
procedures given on page 155.
FWD
FWD
FWD
FWD
FWD