Instruction manual

Hardware and Endpoints
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Disconnecting a Headset
Page 97
Disconnecting a Headset
The following procedures describe how to disconnect a headset from an Inter-Tel endpoint.
To disconnect the headset from a Model 8620 or 8660 IP or a Model 8520 or 8560 digital
endpoint:
1. Unplug the headset cord from the back of the endpoint.
2. While on-hook, enter the Headset Off feature code (316) or the Headset On/Off feature
code (317). The display shows
HEADSET MODE OFF.
To disconnect the headset from all other Inter-Tel endpoints:
1. Unplug the headset cord from the base of the endpoint.
2. Plug the coiled handset cord into the base of the endpoint.
3. While on-hook, enter the Headset Off feature code (316) or the Headset On/Off feature
code (317). The display shows
HEADSET MODE OFF.
Digital Endpoints
With the addition of Digital Expansion Interface (DEI) equipment and appropriate licensing,
the Inter-Tel 5000 Network Communications Solutions platform supports the following digital
endpoints.
• Hard
digital endpoints
– Model 8500
– Model 8520, two-line display
– Model 8560, six-line display
– Associate
– Standard
– Executive
– Professional
–Basic
• Single-Line Adapter (SLA)
• Single Line endpoints
• Modem Data Port Module (MDPM)
• Personal Computer Data Port Module (PCDPM), audio only