Instruction manual

Hardware and Endpoints
INTER-TEL
®
5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007
Keymaps
Page 93
• Feature Button: Programmed with feature codes. The feature code appears in the same
button location on all endpoints assigned to the keymap and cannot be changed by the
endpoint user.
• Forward Button: Can be programmed with any of the Call Forwarding feature codes.
The forwarding code used by the button can be changed by the endpoint user.
• Hunt Group Button: Like DSS buttons, this button dials a hunt group pilot number
when pressed and, if assigned to a button with a lamp, will show the status of that hunt
group.
• Individual Trunk Button: This button is associated with one trunk. It can be used for
placing outgoing calls, and for picking up calls on hold and answering incoming calls
on that trunk.
• Intercom (IC) Button: The button allows access to intercom channels for plac-
ing and answering calls. If an button is not assigned, an intercom call will
appear under a Call button.
• Next Button: Not required for digital endpoints. Digital endpoints use the Volume but-
ton for scrolling forward through displays.
• Page Zone Button: A page zone button is programmed with one of the page access
codes (9600–9609 or 9600–9649 depending on the software version) for quick access to
page zones (0–9 or 0–49 respectively).
• Previous Button: Not required for digital endpoints. Digital endpoints use the Volume
button for scrolling backward through displays.
• Programmable Button: Up to 35 user-programmable buttons can be designated and
given default values in the keymap database. They can then be reprogrammed to enter
any of the trunk group access codes, extension numbers, or feature codes by the indi-
vidual endpoint users as wanted. Or, they can be programmed as System or Station
Speed Dial bins, or as secondary extension buttons (see below). The endpoint user or
programmer can return the buttons to default values at any time.
• Save Button: Used for saving volume levels or programmed endpoint features. Digital
endpoints use the Volume button, by pressing both ends at once.
• Secondary Extension Button: Allows an endpoint user to have one-button access to
calls ringing or holding at another endpoint. It should be assigned to a button with a
lamp so that the secondary extension button can show the call status. If necessary, an
endpoint can have several secondary extension buttons, each associated with a different
station. For details, see page 154.
• SPKR Button: Used for turning the endpoint speaker or headset on and off.
• Speed Dial Buttons: Each keymap can have up to 10 Speed Dial buttons. Each Speed
Dial button can be programmed by the endpoint user to dial one digit string. If assigned
to a button with a lamp, the lamp will show the status of an extension number if it is
associated with that button.
• Trunk Group Button: These buttons are associated with specific trunk group access
codes and are used for placing outgoing calls on trunks in the selected trunk group. If
assigned to a button with a lamp, the lamp will be lit if all trunks in the trunk group are
in use.
IC
IC