Technical Manual

Note: The order of the access rules is very important. While processing each packet to filter, the ASA

examines if the packet matches any of the access rule criterion in a sequential order and if a match happens, it

implements the action of that access rule. When an access rule is matched, it does not proceed to further

access rules and verify them again.

Add an Access Rule after an existing one:

Complete these steps in order to create an access rule just after an already existing access rule.

Select the access rule after which you need to have a new access rule, and choose Insert After from

the Add drop−down menu.

Specify the Interface, Action, Source, Destination and Service fields, and click OK to complete the

configuration this access rule.