Leaflet

15-10

思科 ASA 系列命令参考，A 至 H 命令

第 15 章 failover 至 fallback 命令

failover exec

Interface GigabitEthernet0/2 "failover", is up, line protocol is up

Hardware is i82546GB rev03, BW 1000 Mbps

Auto-Duplex(Full-duplex), Auto-Speed(100 Mbps)

Description: LAN/STATE Failover Interface

MAC address 000b.fcf8.c293, MTU 1500

IP address 10.0.5.2, subnet mask 255.255.255.0

1991 packets input, 408734 bytes, 0 no buffer

Received 1 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 L2 decode drops

1835 packets output, 254114 bytes, 0 underruns

0 output errors, 0 collisions

0 late collisions, 0 deferred

input queue (curr/max blocks): hardware (0/0) software (0/0)

output queue (curr/max blocks): hardware (0/2) software (0/0)

Traffic Statistics for "failover":

1913 packets input, 345310 bytes

1755 packets output, 212452 bytes

0 packets dropped

1 minute input rate 1 pkts/sec, 319 bytes/sec

1 minute output rate 1 pkts/sec, 194 bytes/sec

1 minute drop rate, 0 pkts/sec

5 minute input rate 1 pkts/sec, 318 bytes/sec

5 minute output rate 1 pkts/sec, 192 bytes/sec

5 minute drop rate, 0 pkts/sec

以下示例展示当向对等设备发出非法命令时返回的错误消息：

ciscoasa# failover exec mate bad command

bad command

ERROR: % Invalid input detected at '^' marker.

以下示例展示在禁用故障切换的情况下使用 failover exec 命令时返回的错误消息：

ciscoasa(config)# failover exec mate show failover

ERROR: Cannot execute command on mate because failover is disabled