Manual

Command Purpose
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
6-33
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 6 Configuring Radio Settings
Configuring the Maximum Data Retries
Use the no form of the command to reset the RTS settings to defaults.
Configuring the Maximum Data Retries
The maximum data retries setting determines the number of attempts the wireless device makes to send
a packet before giving up and dropping the packet.
The default setting is 32. Beginning in privileged EXEC mode, follow these steps to configure the
maxi
mum data retries:
Command Purpose
Step 1
Step 2
Step 3
Step 4
Step 5
Use the no form of the command to reset the setting to defaults.
configure terminal Enter g
lobal configuration mode.
interface dot11radio {0 | 1}
Enter interface configuration mode for the radio interface.
The 2.4-GHz radio and the 2.4-GHz 802.11n radio is 0.
The 5-GHz radio and the 5-GHz 802.11n radio is 1.
rts threshold value S
et the RTS threshold. Enter an RTS threshold from 0 to 2347.
rts retries value Set
the maximum RTS retries. Enter a setting from 1 to 128.
end Retu
rn to privileged EXEC mode.
copy running-config startup-config (Op
tional) Save your entries in the configuration file.
configure terminal Enter global configuration mode.
interface dot11radio {0 | 1}
Enter interface configuration mode for the radio interface.
The 2.4-GHz radio and the 2.4-GHz 802.11n radio is 0.
The 5-GHz radio and the 5-GHz 802.11n radio is 1.
packet retries value
Set the maximum data retries. Enter a setting from 1 to 128.
end Retu
rn to privileged EXEC mode.
copy running-config startup-config (Op
tional) Save your entries in the configuration file.