Design Guide

182
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
Adding and Managing Mesh Access Points with Cisco WCS
Figure 109 Access Point > AP Name
Listed below is a summary of each of the possible Last Reboot Reasons that might be reported and its
definition:
• none–Access point reported a reboot reason unknown to the controller
• dot11gModeChange–Change of 802.11g mode change occurred
• ipAddressSet–Set of static IP address
• ip AddressReset–Reset of static IP address
• rebootFromController–Reboot of access point initiated from the controller
• dhcpFallbackFail–Fallback to DHCP did not occur
• discoveryFail–Discovery was not sent
• noJoinResponse–Join response was not received
• denyJoin–Join attempt at the controller was denied
• noConfigResponse–Config Response was not received
• configController–Configured or master controller found
• imageUpgrade Success–Upgrade of image successful
• imageOpcodeInvalid–Invalid image data opcode
• imageCheckSumInvalid–Invalid image md 5 checksum
• imageDataTimeout–Image data message timed-out
• configFileInvalid–Invalid config file
• imageDownloadError–Process error during the image download
• rebootFromConsole–Reboot command initiated from AP console